One，hollow blow molding machine

1) clockwise rotation of the hollow blow molding machine, single screw extruder, the main power switch, the horizontal state (OFF state) to rotate to the vertical state (ON state).

2) press the green power button on the control panel of the extruder.

3) press the blue reset button on the control panel of the blow molding machine (R).

4) clockwise control panel power switch of the hollow blow molding machine, from the closed position (02) to open position (1).

5) the temperature of each part of the extruder barrel is set on the control panel of the extruder
.
6) the temperature of each part of the die set on the control panel of the hollow blow molding machine.

7) set the parameters of each step of the blowing bottle on the touch screen of the hollow blow molding machine.

8) add the material into the hopper of the extruder and rotate the hopper to the feed position.

9) all parts to achieve the set temperature, wait about 15 minutes to ensure that the temperature is stable.

10) press the green start button on the control panel of the extruder, start the screw, control the speed of the screw on the control panel of the extruder, and set the rotation speed of the screw.

11) press the green start button on the control panel of the blow molding machine to start the motor pump.

12) the mode ion switch on the control panel of the hollow blow molding machine, and make the automatic operation mode.

13) from the die head out of the material to achieve the appropriate length, press the green button on the control panel of the hollow blow molding machine, start blowing cycle.

Two, closed hollow blow molding machine

1) after the blowing cycle is finished, press the red stop button on the control panel of the blow molding machine to stop the motor pump.

2) the extruder hopper to the stop position.

3) extrusion machine barrel materials squeezed empty after, rotating extruder control panel on the screw speed control knob extruded screw machine speed is set to zero, according to the extruder control panel on the red stop button, stop screw.

4) the counterclockwise rotation of hollow blow molding machine control panel power switch, the open position (1) to the closed position (02).

5) press the red power button on the control panel of the extruder.

6) counter clockwise rotation of the hollow blow molding machine, single screw extruder, the main power switch, the vertical state (ON state) to the horizontal state (OFF state).

Three, pay attention to matters

 when the normal use, do not use the emergency device (emergency stop button) to stop the device.

bottle blowing machine |SNTO| blowing machinepet, blowing pet